Having painted up an SdKfz 250-based Aufklarung platoon for my late war infantry, it was only appropriate to sort the panzers out as well with an Sdkfz 250-based platoon from the Panzerspahkompanie.

Slightly different configuration from the Aufklarung platoon: with two command SdKfz 250/5 vehicles backed up by four 20mm cannon armed SdKfz 250/9 vehicles.

As with the Aufklarung platoon, the Plastic Soldier Company could provide the 250/9s, but no-one seemed to do a specific 250/5 i.e. the half-track with the extra radio equipment in it.

So I decided to go a bit off-the-books here and make the two cars SdKfz 250/3s (i.e. the ones with the aerial cage on top) instead of 5s. This meant that they would be clearly distinguishable from a run-of-the-mill 250, and maybe there were some 5s that had the cage. Google certainly suggested a whole lot of different types of "extra radio equipment", from hoops to tall cactus-like aerials etc.

The problem, of course, is that just as no-one did a 250/5, no-one did a 250/3 either!

Searching the web, however, led me to the 15mm figure manufacturer Heer46. They produce a separate aerial cage for the SdKfz 251/3, and although the cages weren't identical, I thought this was a close enough match and ordered a couple. 

Delivery was prompt, and with a bit of bending and squeezing, the cages fitted the smaller half-tracks just fine. Okay, so they have a cross-brace in the middle, and the 250/3 cage doesn't, but maybe these particular crews fitted extra struts because of high winds in the area in which they were operating!

I painted them in the same way as with the Aufklarung (see previous post) i.e. a base of dunkelgelb then sponged on camouflage, and they turned out equally as well. The only problem was that, again, and with a new can, I've had a frosting issue with GW Purity Seal.

Don't understand it. I switched away from Purity seal as my varnish of choice about ten years ago when I encountered a really bad batch that even GW (reluctantly) admitted was crap. Then, after a few years, I switched back...mainly because of the convenience of being able to pop into a GW store to pick up a replacement. I've had no problems, none at all, since then, until now.

Now I have had not one but two cans, bought from different stores, give my figures a nasty case of dusty frosting. Don't know why, and will have to buy a can of something else to see if an overspray works to clear it. Hope so, as I really don't fancy building and painting another fourteen SdKfz 250s!